MSO 5062D HANTEK
| Model | MSO5202D | MSO5102D | MSO5062D |
| Acquisition | |||
| Sample Rate | Real-Time Sample: 1GS/s | ||
| Acquisition Modes | |||
| Normal | Normal data only | ||
| Peak Detect | High-frequency and randon glith capture | ||
| Average | Waveform Average, selectable 4,8,16,32,64,128 | ||
| Inputs | |||
| Inputs Coupling | AC, DC, GND | ||
| Inputs Impendance | 1MΩ±2% ‖20pF±3pF | ||
| Probe Attenuation | 1X, 10X | ||
| Supported Probe Attenuation Factor | 1X, 10X, 100X, 1000X | ||
| Maximum Input Voltage | CAT I and CAT II: 300VRMS (10×), Installation Category; CAT III: 150VRMS (1×); Installation Category II: derate at 20dB/decade above 100kHz to 13V peak AC at 3MHz* and above. For non-sinusoidal waveforms, peak value must be less than 450V. Excursion above 300V should be of less than 100ms duration. RMS signal level including all DC components removed through AC coupling must be limited to 300V. If these values are exceeded, damage to the oscilloscope may occur. | ||
| Horizontal | |||
| Sample Rate Range | 500MS/s--1GS/s | ||
| Waveform Interpolation | (sin x)/x | ||
| Record Length | 1M | ||
| SEC/DIV Range | 2ns/div to 40s/div, | 8ns/div to 40s/div | |
| Sample Rate and Delay Time Accuracy | ±50ppm（at over any ≥1ms time interval) | ||
| Position Range | 2ns/div to 8ns/div; (-8div x s/div) to 20ms; | 20ns/div to 80us/div; (-8div x s/div) to 40ms; 200us/div to 40s/div; (-8div x s/div) to 400s; | |
| Delta Time Measurement Accuracy (Full Bandwidth) | Single-shot, Normal mode:± (1 sample interval +100ppm × reading + 0.6ns); >16 averages:± (1 sample interval + 100ppm × reading + 0.4ns); Sample interval = s/div ÷ 200 | ||
| Vertical System | |||
| Vertical Resolution | 8-bit resolution, all channel sampled simultaneously | ||
| Position Range | 2mV/div to 10V/div | ||
| Bandwidth | 200MHz | 100MHz | 60MHz |
| Rise Time at BNC( typical) | 1.8ns | 3.5ns | 5.8ns |
| Offset Range | 2mV/div to 20mV/div, ±400mV 50mV/div to 200mV/div, ±2V 500mV/div to 2V/div, ±40V 5V/div to 10V/div, ±50V | ||
| Math | +, -, *, /, FFT | ||
| FFT | Windows: Hanning、Flatop、Rectamgular、Bartlett、Blackman; 1024 sample point | ||
| Bandwidth Limit | 20MHz | ||
| Low Frequency Response (-3db) | ≤10Hz at BNC | ||
| DC Gain Accuracy | ±3% for Normal or Average acquisition mode, 10V/div to 10mV/div; ±4% for Normal or Average acquisition mode, 5mV/div to 2mV/div | ||
| DC Measurement Accuracy, Average Acquisition Mode | When vertical displacement is zero, and N ≥16:± (3% × reading + 0.1div + 1mV) only 10mV/div or greater is selected; When vertical displacement is not zero, and N≥16: ± [3% × (reading + vertical position) + 1% of vertical position + 0.2div]; Add 2mV for settings from 2mV/div to 200mV/div; add 50mV for settings from 200mV/div to 10V/div | ||
| Volts Measurement Repeatability, Average Acquisition Mode | Delta volts between any two averages of ≥16 waveforms acquired under same setup and ambient conditions | ||
MSO 5062D HANTEK
- Views: 1040
-
Hantek
- Product: Digital Storage Oscilloscope 60MHZ
- Availability: PREORDER
- Rs 53,000 Free Shipping
PREORDER
DSO5072P Hantek
ModelDSO5202PDSO5102PDSO5072PAcquisitionSample RateReal-Time Sample: 1GS/sEquivalent Sample: 25GS/sA..
Rs 48,500
PREORDER
DSO 4072C HANTEK
ModelDSO4202CDSO4102CDSO4072COscilloscopeSample RateSampling Rate Range: 1GSa/sEquivalent Sample Rat..
Rs 52,500
PREORDER
MSO 5102D HANTEK
ModelMSO5202DMSO5102DMSO5062DAcquisitionSample RateReal-Time Sample: 1GS/sAcquisition ModesNormalNor..
Rs 71,000
PREORDER
MSO 5202D HANTEK
ModelMSO5202DMSO5102DMSO5062DAcquisitionSample RateReal-Time Sample: 1GS/sAcquisition ModesNormalNor..
Rs 82,500
PREORDER
DSO 5062B HANTEK
ModelDSO5202BDSO5102BDSO5062BAcquisitionSample RateReal-Time Sample: 1GS/sEquivalent Sample: 25GS/sA..
Rs 58,500
PREORDER
DSO 5102B HANTEK
ModelDSO5202BDSO5102BDSO5062BAcquisitionSample RateReal-Time Sample: 1GS/sEquivalent Sample: 25GS/sA..
Rs 59,500
PREORDER
DSO 5202B HANTEK
ModelDSO5202BDSO5102BDSO5062BAcquisitionSample RateReal-Time Sample: 1GS/sEquivalent Sample: 25GS/sA..
Rs 67,000